Superb

When did you design this? I remember printing a very similar phone stand years ago. I used it for a long time, it was great!

NixOS is great if you’re ready to learn Nix, which is an undertaking

After watching the video I’m not certain what it could be, but I’ve heard similar before from my printer so I’ll list them in order of sound similarity:

• My X belt wasn’t fully aligned in its track and it was rubbing on the side, which caused a similar clicked noise when any X move occurred.
• When there too much pressure in the hot end (from a clog, low temp, or too close to the bed, etc), I’ve seen the filament “kicking back” out of the extruder. Watch for a sudden backwards jerk of the filament.
• My X stepper motor made some terrible noises after tightening the associated belt. I’m not sure what’s causing it exactly, but I’m replacing the stepper soon.

I’ve just started my switch to PETG and I don’t think I’m going back!

I think you’re overthinking it, also the tweets are in the wrong order chronologically in your story. The smaller tweet happened first

This is excellent! Does anyone know if the PinePhone Pro supports eSIM?

This is possible! At least, I’ve seen it described in other people’s setups. Having the integrated GPU should help in this case.

If I remember correctly, you need to make sure the vm shuts down properly so that it shuts down the graphics card properly. Then you can unload the vfio-pci module and load the correct module for your card.

Two great resources are the subreddit (unfortunately) r/vfio and the arch wiki page: https://wiki.archlinux.org/title/PCI_passthrough_via_OVMF

I really like this! This might solve my problem of noticing a chore needs to be done but being too busy to take care of it in the moment and immediately forgetting

In what situation would those two not be the same?

Yeah the line can get pretty ambiguous. In general I try to use the device with the least complexity that still gets the job done

A router usually can do all that but it also does a whole lot more, like NAT, DHCP, etc. Sometimes you need a just a switch that understands VLANs and link aggregation

sudo rm -rf --no-preserve-root /

You’re better off with any other distro

Oh wow, TIL! I guess I’m not surprised, consumer GPS is kneecapped at a lower accuracy for similar reasons

Do I need a background check to buy a CNC? Or a lathe?