For work or school stuff sure, those are org settings.

You still have to turn that on.

See my comment about Resilio sync above

Resilio sync works great for that since syncthing is on the out. I actually prefer Resilio anyways

I know I’m in a different situation here but i buy all my server drives off ebay. Just got ~60TB worth of SAS drives for a little over $200 USD. Ive never had an issue. Most of these places are where business sell their drives to be wiped. Then they just put them up on ebay

Edit: bad autocorrect

Of course, it says actors, there are actresses that are worth more than $1 billion

Been using ShareX for a bit today, yep, you are right. Far superior. Glad I stumbled on this today!

Have you ever used lightshot? How did sharex compare if you have.

I’ve been using lightshot for years and love it, might have to try others out just to see what else is out there

Edit: Been using ShareX for a little bit today, and yes. it is superior to lightshot

In the US it’s required by commercial building codes in certain situations

I use /srv for all mu shared mounts for all the *arr’s

I went the Solid works hobbyist route, quite frankly, it’s well worth it. I tried freecad for awhile but it just didn’t compare.

I tried Resolve bit came back to kdenlive. It’s just fit my needs much better

The beauty of open source software

I’d say all of the above. Its integration with Kipper is also very good

Which is a fork of Slic3r

And it’s fantastic!

Edit: its actually a fork of bamboo slicer which is a fork of prusa slicer

I used to slicer hop around, then i discovered orca. Just the best imho

Edit: its an open source fork of bamboo slicer

It does, two buttons along the side of the stylus and one on the top end

I have the dell active pen on my xps 2 in 1, it works.